|
Product Details:
Payment & Shipping Terms:
|
| Power Output: | 5W | Control Distance: | 10km |
|---|---|---|---|
| Application: | PLC Wireless Control | Enclosure: | Aluminium |
| Interface: | RS232, RS485, USB | Power Supply: | 24V DC |
| High Light: | data radio modem,serial radio modem |
||
5W 24V Power Supply Wireless RS485 Module PLC Wireless Communication Radio
1. General Introduction
This is a 5W radio for long distance wireless data transfer. Its control distance reaches around 10km. It is widely used for PLC wireless communication. We support Modbus RTU protocol. LS-R524 DTU can be connected with transducer, HMI and sensors for wireless communication. It supports point to point, point to multi-points wireless data transmission. Wireless solution has the advantage of keep users from wiring cables in dangerous field, easy to set up, no need program knowledge. It is a reliable and competitive solution.
2. Technical specification
| Frequency | 433MHz or 450MHz, 470MHz |
| Power Output | 5W |
| Protocol support | Standard Modbus RTU or PPI |
| Power supply | 9-36V DC usually use 24V DC or 12V DC |
| Interface | RS-485(default)or RS232 or USB |
| Channel No. | 15 channel, use DIP to change |
| Antenna | Free sucker antenna with 1.5m cable(buy 5.5dBi sucker antenna) |
| Temperature | -35℃~+75℃ (industrial) |
| Dimension | 175×115×32(mm) exclude antenna |
| Fix method | Screw |
3. LS-R524 Application examples:
4. LS-R524 DTU networking
LS-R524 DTU adopts half-duplex communication mode. It suits point to multipoints communication. In this way, we should set 1 module as master and others as slaves. Each slave has its own unique ID. Master uses data frame with ID to transmit data or command. All slaves will receive data and compare the received ID with its own ID. If ID is the same, receive it and give corresponding response according the command . If ID is different, just ignore it, give no response. All these should finish by upper protocol. It can promise there is only one radio is in transmitting mode in any time to avoid interference.
LS-R524 RTU can also use for point to point communication. This is more easier. When you program serial port, please note it is half-duplex and there is wireless transmission delay.
5. LS-R524 DTU DIP switch setting
DIP3 ON means 4
DIP4 ON means 8
For example, channel 15, you need to set DIP 1, 2, 3 and 4 all ON
Contact Person: Sunny
Tel: +8613826574847
433MHz RF Data Module 100mW Wireless Data Transfer 1km RS232 RS485 TTL
433MHz RF Data Module , Wireless Rf Transmitter 2KM Wireless Transceiver Module For AMR
100mW Wireless Data Module 433MHz Wireless Data Transfer For 500m Serial Data
100mW Wireless Data Module RS232 Interface 500m Wireless Data Transmission 433MHz
Intelligent Wireless Irrigation Controller , Irrigation Program Wireless Sprinkler Controller
9-12V Wireless Irrigation Controller Wire Solution Sub Decode Board 128 Station Decode Board
Underground Internet Controlled Sprinkler System Intelligent For Pulse Drive Solenoid
433MHz Wireless irrigation System Solenoid Valve On-Off Control
433MHz Wireless Tank Level Monitoring System HMI wireless control pump ON OFF 2km
2DI2DO PLC Wireless Pump Control / Relay / Valve 433MHz Wireless ON OFF Control
Pump ON-OFF Control System According the Float Switch High Or Low Level
10DI 10DO Wireless Modbus RTU 10 Digital Inputs 10 Relay Outputs 2km Wireless ON OFF Control
